8/11/2023 0 Comments Cordless drill holder![]() Use something aggressive like 60 or 80 grit to make this step go faster. Step 6: Clean up the slot with a 1-1/2″ drum sander or sanding block. It’s ok if your lines are not the straightest, they’ll be cleaned up in the next step. Take your time, cut level, part of the jigsaw base will be suspended in the air. Step 5: Cut the straight lines with the Jigsaw or Oscillating Multi-tool. A hole bit is preferred but I couldn’t find my 1-1/2″ size when I made this. I used a spade bit but eye protection is definitely needed. Step 4: Use a 1-1/2″ bit to drill the rounded part of the slot. Step 3: Secure 8″ section in vise (or screw it down to the workbench) and mark a 1-1/2″ slot 5″ deep and round over the end. Miter saw will cut it faster and straighter but recip will work too. Step 2: Cut pipe with Miter or Reciprocating saw. You could also use black ABS pipe but it’s more expensive and the melt point is lower so you would have to sand slower. Home Depot sells these sections for just a few bucks. Step 1: Buy 2′ section of 3″ PVC pipe and mark it at 8 and 16 inches with sharpie. Sanding block or sanding drum for the drill.Both 12V and 18V RIDGID tools and Milwaukee M12 tools fit in a 1-1/2″ slot but be sure to measure your tools to figure out the width slot you’ll need. I made 2 sets to hold 3 drills, 2 impacts, and an oscillating multi-tool but you can adapt this project to your needs. It’s so cheap that you could make a set for your friend or family member that could also use a little shop organization. Today I’ve got a quick and cheap project to get you a little shop time, organize all your drills and impact drivers, and not cost more than $10. I’m notorious for doing that and it really bugs my wife. Perhaps your friends and family told you not to buy any tools this season lest you wreck their intentions to buy you tools. If your schedule is anything like mine shop time is a little hard to come by and money for tools or supplies might be a little tighter. ![]() The holiday season is definitely upon us now.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |